Users Manual

LTE Standard Module Series
EC25 Hardware Design
EC25_Hardware_Design
66
/ 130
on normally, the STATUS will present the low state. Otherwise, the STATUS will present high-impedance
state.
Table 22: Pin Definition of STATUS
The following figure shows different circuit designs of STATUS, and customers can choose either one
according to customers’ application demands.
Figure 30: Reference Circuits of STATUS
The status pin cannot be used as indication of module shutdown status when VBAT power supply is
removed.
3.19. Behaviors of RI
AT+QCFG="risignaltype","physical" command can be used to configure RI behavior.
No matter on which port a URC is presented, the URC will trigger the behaviors of RI pin.
URC can be outputted from UART port, USB AT port and USB modem port through configuration via
AT+QURCCFG command. The default port is USB AT port.
Pin Name Pin No. I/O Description Comment
STATUS 61 OD Indicate the module’s operation status
An external pull-up resistor
is required.
If unused, keep it open.
NOTE
NOTES