Product Info
Table Of Contents
- About the Document
- Contents
- Table Index
- Figure Index
- 1Introduction
- 2Product Concept
- 3Application Interfaces
- 4Antenna Interface
- 5Reliability and Electrical Characteristics
- 6Mechanical Features
- 7Storage, Manufacturing and Packaging
- 8Appendix A References
NB-IoT Module Series
BC660K-GL Hardware Design
BC660K-GL_Hardware_Design
4-38
/ 59
Figure 19: Reference Design of NB-IoT Antenna Interface
4.4. Reference Design of RF Layout
For users’ PCB, the characteristic impedance of all RF traces should be controlled to 50 Ω. The
impedance of the RF traces is usually determined by the trace width (W), the materials’ dielectric constant,
height from the reference ground to the signal layer (H), and the clearance between RF traces and
grounds (S). Microstrip or coplanar waveguide is typically used in RF layout to control characteristic
impedance. The following are reference designs of microstrip or coplanar waveguide with different PCB
structures.
.
Figure 20: Microstrip Design on a 2-layer PCB