Product Info

Automotive Module Series
AG521R-NA QuecOpen Hardware Design
AG521R-NA_QuecOpen_Hardware_Design 65 / 92
The following principles of PCIe interface design should be complied with, so as to meet PCIe Gen2 specifications.
⚫ It is important to route the PCIe signal traces as differential pairs with ground surrounded. And the differential
impedance is 95 Ω ±10%.
⚫ For PCIe signal traces, the maximum length of each differential data pair (TX/RX/REFCLK) is recommended
to be less than 270 mm, and each differential data pair matching should be less than 0.7 mm (5 ps).
⚫ Spacing data lane-to-lane (intra-interface) is three times of line width.
⚫ Spacing to all other signals (inter-interface) is four times of line width.
⚫ Do not route signal traces under crystals, oscillators, magnetic devices or RF signal traces. It is
important to route the PCIe differential traces in inner-layer with ground shielding on not only upper
and lower layers but also right and left sides.
3.17. ADC Interfaces
The module provides three analog-to-digital converter (ADC) interfaces. The voltage value on ADC pins can be
read via AT+QADC=<port> command, through specifying <port> as 0, 1 or 2. For more details about the AT
command, see document [3].
⚫ AT+QADC=0: read the voltage value on ADC0
⚫ AT+QADC=1: read the voltage value on ADC1
In order to improve the accuracy of ADC, the traces of ADC interfaces should be surrounded by ground.
Table 24: Pin Definition of ADC Interfaces
Pin Name
Pin No.
Description
ADC1
245
General purpose ADC interface
ADC0
247
General purpose ADC interface
Table 25: Characteristic of ADC Interface
Parameter
Min.
Typ.
Max.
Unit
ADC0 Voltage Range
0
1.875
V
ADC1 Voltage Range
0
1.875
V
ADC Resolution
14
bits