User's Manual

Wi-Fi&Bluetooth Module Series
FC41D_Hardware_Design
48 / 46
Hereby, [Quectel] declares that the radio equipment type [Stand-alone Wi-Fi&Bluetooth
Module] is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
https://www.quectel.com/shop
OEM/Integrators Installation Manual
Important Notice to OEM integrators
1.This module is limited to OEM installation ONLY.
2. This module is limited to installation in mobile or fixed applications, according to Part
2.1091(b).
3.The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations
4.For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to
verify compliance as a composite system. When testing the host device for compliance with
Part 15 Subpart B, the host manufacturer is required to show compliance with Part 15 Subpart
B while the transmitter module(s) are installed and operating. The modules should be
transmitting and the evaluation should confirm that the module's intentional emissions are
compliant (i.e. fundamental and out of band emissions). The host manufacturer must verify that
there are no additional unintentional emissions other than what is permitted in Part 15 Subpart
B or emissions are complaint with the transmitter(s) rule(s). The Grantee will provide guidance
to the host manufacturer for Part 15 B requirements if needed.
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop configurations or
co-location with another transmitter), then the FCC authorization is no longer considered valid
and the FCC ID can not be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
End Product Labeling
The final end product must be labeled in a visible area with the following:
Contains FCC ID:XMR20211108FC41D ; IC :10224A-20211108FC41D.
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module in the user’s manual of the end product which integrates this
module.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,