Product Info

Bluetooth Module Series
HC06U_Hardware_Design 33 / 31
Federal Communications Commission (FCC) Declaration of Conformity FCC Caution: Any
changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC
Rules.Operation is subject to the following two conditions: 1. This device may not cause harmful
interference, and 2. this device must accept any interference received, including interference that
may cause un-desired operation. Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equip-ment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures: —Reorient or relocate the
receiving antenna. —Increase the separation between the equipment and receiver. —Connect
the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help. Radiation Exposure
Statement This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled rolled environment. This equipment should be installed and operated with minimum
distance 20cm between the radiator and your body. Important Note
：
This radio module must not
installed to co-locate and operating simultaneously with other radios in host system except in
accordance with FCC multi-transmitter product procedures. Additional testing and equipment
authorization may be required to operating simultaneously with other ra-dio. The availability of
some specific channels and/or operational frequency bands are country dependent and are
firmware programmed at the factory to match the intended destination. The firmware setting is not
accessible by the end user. The host product manufacturer is responsible for compliance to any
other FCC rules that apply to the host not covered by the modular transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing with the mod-ular