Product Info

LPWA Module Series
BG95 Series Hardware Design
BG95_Series_Hardware_Design 58 / 106
Table 23: Pin Definition of ADC Interface
Pin Name Pin No. I/O Description Comment
ADC0 24 AI General-purpose ADC interface
Do not use ADC0 and
ADC1 simultaneously.
ADC1 2 AI General-purpose ADC interface
The following table describes the characteristics of ADC interfaces.
Table 24: Characteristics of ADC Interfaces
1. ADC input voltage must not exceed 1.8 V.
2. It is prohibited to supply any voltage to ADC pin when VBAT is removed.
3. It is recommended to use resistor divider circuit for ADC application, and the divider resistor accuracy
should be no less than 1 %.
4. Do not use ADC0 and ADC1 simultaneously, as ADC1 connects directly to ADC0 inside the module.
3.18. GPIO Interfaces
The module provides nine general-purpose input and output (GPIO) interfaces. AT+QCFG="gpio"
command can be used to configure the status of GPIO pins. For more details about the AT command, see
document [2].
Parameter Min. Typ. Max. Unit
Voltage Range 0.1 1.8 V
Resolution (LSB) 64.979 μV
Analog Bandwidth 500 kHz
Sample Clock 4.8 MHz
Input Resistance 10 MΩ
NOTES