Data Sheet

Absolute Maximum Ratings
1,2,3
Recommended Operating Conditions
1,2
Parameter Symbol Min Typ. Max Unit Test Condition
Supply Voltage VCC VCC 3.1 3.5 4.6 V
Supply Voltage VBATT VBATT 0.9 3.5 4.6 V
MIPI Supply VIO 1.65 1.8 1.95 V
MIPI Signal Level (SCLK,SDATA)
V
_MIPI_LOW
0 0.2*VIO V Signal Level Low
V
_MIPI_HIGH
0.8*VIO 1.8 VIO V Signal Level High
Leakage Current (VBATT) I
_LEAK
20 uA
Applied DC Only
：
VCC = VBATT = 4.6V, VIO = 0V
TRx Mode Current I
_TRx
150 300 uA Ta= 25°C
Operating Temperature Range T
_range
-25 +25 +85 °C
1. Exceeding any one more maximum rating conditions for extended periods may reduce device reliability and also may cause permanent damage to the
device.
2. There is no damage to device with only one parameter set at the limit at a time and all other parameters set at recommended operating conditions.
3. Applied voltage must be current-limited to specified range.
Parameter Symbol Min. Typ. Max. Unit
Supply VBATT -1.2 – 6 V
Power Control Voltage Vramp -0.3 – 3 V
Input RF Power Pin – – 15 dBm
Max. Burst Duty Cycle DT – – 50 %
Output Load VSWR (Ruggedness) Ru – – 20:1 VSWR
Current Continuous During Burst
3
I
_VBATT
2.5 A
MIPI Supply Voltage VIO – – 2 V
MIPI Data and Clock Voltage V
_SDATA,SCLK
––2 V
Operating Case Temperature T
_CASE
-30 – +100
°
C
Storage Temperature T_
STG
-40 – +150
°
C
Reflow Solder Temperature (J-STD-020B) T_
SOLDER
+260 – –
°
C
Moisture Sensitivity Level MSL 3
ESD Antenna Port ESD_
ANT
-8 – +8 KV
ESD All Pins (Charge Device Model) ESD_
CDM
-1 – +1 KV
ESD All Pins (Human Body Model) ESD_
HBM
-1 – +1 KV
1. Normal Test Condition (NTC), defined as VBATT = VCC = 3.5V, Ta = 25°C
2. Extreme Test Condition (ETC), defined as VBATT = VCC = 3.1V to 4.6V, T = T
_range
4
All rights reserved.
Products and Product Information are Subject to Change Without Prior Notice.
Preliminary Datasheet Vanchip Confidential VC7916-62