Product Info

LPWA Module Series

BG600L-M3 Hardware Design

BG600L-M3_Hardware_Design 11 / 83

❒ NB LTE Band4/66:≤8.000dBi

❒ NB LTE Band5:≤12.541 dBi

❒ NB LTE Band12:≤11.798dBi

❒ NB LTE Band13:≤12.214dBi

❒ NB LTE Band71:≤11.687dBi

❒NB LTE Band85:≤11.798 dBi

This module must not transmit simultaneously with any other antenna or transmitter

6. The host end product must include a user manual that clearly defines operating requirements and

conditions that must be observed to ensure compliance with current FCC RF exposure guidelines.

For portable devices, in addition to the conditions 3 through 6 described above, a separate approval

is required to satisfy the SAR requirements of FCC Part 2.1093

If the device is used for other equipment that separate approval is required for all other operating

configurations, including portable configurations with respect to 2.1093 and different antenna

configurations.

For this device, OEM integrators must be provided with labeling instructions of finished products.

Please refer to KDB784748 D01 v07, section 8. Page 6/7 last two paragraphs:

A certified modular has the option to use a permanently affixed label, or an electronic label. For a

permanently affixed label, the module must be labeled with an FCC ID - Section 2.926 (see 2.2

Certification (labeling requirements) above). The OEM manual must provide clear instructions

explaining to the OEM the labeling requirements, options and OEM user manual instructions that are

required (see next paragraph).

For a host using a certified modular with a standard fixed label, if (1) the module’s FCC ID is not

visible when installed in the host, or (2) if the host is marketed so that end users do not have

straightforward commonly used methods for access to remove the module so that the FCC ID of the

module is visible; then an additional permanent label referring to the enclosed module:“Contains

Transmitter Module FCC ID: XMR202004BG600LM3” or “Contains FCC ID:

XMR202004BG600LM3” must be used. The host OEM user manual must also contain clear

instructions on how end users can find and/or access the module and the FCC ID.

The final host / module combination may also need to be evaluated against the FCC Part 15B criteria

for unintentional radiators in order to be properly authorized for operation as a Part 15 digital device.

The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the

user that changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment. In cases where the manual is provided only

in a form other than paper, such as on a computer disk or over the Internet, the information required

by this section may be included in the manual in that alternative form, provided the user can

reasonably be expected to have the capability to access information in that form.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the manufacturer could void the user’s authority

to operate the equipment.