Product Info
Table Of Contents
- About the Document
- Contents
- Table Index
- Figure Index
- 1 Introduction
- 2 Product Concept
- 3 Application Interfaces
- 3.1. General Description
- 3.2. Pin Assignment
- 3.3. Pin Description
- 3.4. Power Supply
- 3.5. Turn on and off Scenarios
- 3.6. VRTC Interface
- 3.7. Power Output
- 3.8. Battery Charge and Management
- 3.9. USB Interfaces
- 3.10. UART Interfaces
- 3.11. (U)SIM Interfaces
- 3.12. SD Card Interface
- 3.13. GPIO Interfaces
- 3.14. I2C Interfaces
- 3.15. I2S Interfaces
- 3.16. SPI Interface
- 3.17. ADC Interfaces
- 3.18. LCM Interfaces
- 3.19. Touch Panel Interfaces
- 3.20. Camera Interfaces
- 3.21. Sensor Interfaces
- 3.22. Audio Interfaces
- 3.23. Emergency Download Interface
- 4 Wi-Fi and BT
- 5 GNSS
- 6 Antenna Interfaces
- 7 Electrical, Reliability and Radio Characteristics
- 8 Mechanical Dimensions
- 9 Storage, Manufacturing and Packaging
- 10 Appendix A References
- 11 Appendix B GPRS Coding Schemes
- 12 Appendix C GPRS Multi-slot Classes
- 13 Appendix D EDGE Modulation and Coding Schemes
- IC & FCC Requirement
Smart LTE Module Series
SC66 Hardware Design
SC66_Hardware_Design 46 / 139
The timing of turning on Module is illustrated in the following figure.
VBAT (Typ.: 4.0V)
PWRKEY
>3ms
Others
LDO13A_1P8
LDO11A_1P8
Software
controlled
LDO14A_1P8
Active
LDO7B_3P125
Software
controlled
Figure 8: Timing of Turning on Module
Make sure that VBAT is stable before pulling down PWRKEY pin. The recommended time between them
is no less than 30ms. PWRKEY cannot be pulled down all the time.
NOTE