Product Info
Table Of Contents
- About the Document
- Contents
- Table Index
- Figure Index
- 1 Introduction
- 2 Product Concept
- 3 Application Interfaces
- 3.1. General Description
- 3.2. Pin Assignment
- 3.3. Pin Description
- 3.4. Power Supply
- 3.5. Turn on and off Scenarios
- 3.6. VRTC Interface
- 3.7. Power Output
- 3.8. Battery Charge and Management
- 3.9. USB Interfaces
- 3.10. UART Interfaces
- 3.11. (U)SIM Interfaces
- 3.12. SD Card Interface
- 3.13. GPIO Interfaces
- 3.14. I2C Interfaces
- 3.15. I2S Interfaces
- 3.16. SPI Interface
- 3.17. ADC Interfaces
- 3.18. LCM Interfaces
- 3.19. Touch Panel Interfaces
- 3.20. Camera Interfaces
- 3.21. Sensor Interfaces
- 3.22. Audio Interfaces
- 3.23. Emergency Download Interface
- 4 Wi-Fi and BT
- 5 GNSS
- 6 Antenna Interfaces
- 7 Electrical, Reliability and Radio Characteristics
- 8 Mechanical Dimensions
- 9 Storage, Manufacturing and Packaging
- 10 Appendix A References
- 11 Appendix B GPRS Coding Schemes
- 12 Appendix C GPRS Multi-slot Classes
- 13 Appendix D EDGE Modulation and Coding Schemes
- IC & FCC Requirement
Smart LTE Module Series
SC66 Hardware Design
SC66_Hardware_Design 12 / 139
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement."
The device could automatically discontinue transmission in case of absence of information to transmit, or
operational failure. Note that this is not intended to prohibit transmission of control or signaling information
or the use of repetitive codes where required by the technology.
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems;
The maximum antenna gain permitted for devices in the bands 5250–5350 MHz and 5470–5725 MHz shall
comply with the e.i.r.p. limit; and
The maximum antenna gain permitted for devices in the band 5725–5825 MHz shall comply with the e.i.r.p.
limits specified for point-to-point and non point-to-point operation as appropriate.
L'appareil peut interrompre automatiquement la transmission en cas d'absence d'informations à
transmettre ou de panne opérationnelle. Notez que ceci n'est pas destiné à interdire la transmission
d'informations de contrôle ou de signalisation ou l'utilisation de codes répétitifs lorsque cela est requis par
la technologie.
Le dispositif utilisé dans la bande 5150-5250 MHz est réservé à une utilisation en intérieur afin de réduire
le risque de brouillage préjudiciable aux systèmes mobiles par satellite dans le même canal;
Le gain d'antenne maximal autorisé pour les dispositifs dans les bandes 5250-5350 MHz et 5470-5725
MHz doit être conforme à la norme e.r.p. limite; et
Le gain d'antenne maximal autorisé pour les appareils de la bande 5725-5825 MHz doit être conforme à
la norme e.i.r.p. les limites spécifiées pour un fonctionnement point à point et non point à point, selon le
cas.
CAN ICES-3(B)/ NMB-3(B)
Radiation Exposure Statement
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20 cm between the radiator &
your body.










