Product Info
Table Of Contents
- About the Document
- Contents
- Table Index
- Figure Index
- 1 Introduction
- 2 Product Concept
- 3 Application Interfaces
- 3.1. General Description
- 3.2. Pin Assignment
- 3.3. Pin Description
- 3.4. Power Supply
- 3.5. Turn on and off Scenarios
- 3.6. VRTC Interface
- 3.7. Power Output
- 3.8. Battery Charge and Management
- 3.9. USB Interfaces
- 3.10. UART Interfaces
- 3.11. (U)SIM Interfaces
- 3.12. SD Card Interface
- 3.13. GPIO Interfaces
- 3.14. I2C Interfaces
- 3.15. I2S Interfaces
- 3.16. SPI Interface
- 3.17. ADC Interfaces
- 3.18. LCM Interfaces
- 3.19. Touch Panel Interfaces
- 3.20. Camera Interfaces
- 3.21. Sensor Interfaces
- 3.22. Audio Interfaces
- 3.23. Emergency Download Interface
- 4 Wi-Fi and BT
- 5 GNSS
- 6 Antenna Interfaces
- 7 Electrical, Reliability and Radio Characteristics
- 8 Mechanical Dimensions
- 9 Storage, Manufacturing and Packaging
- 10 Appendix A References
- 11 Appendix B GPRS Coding Schemes
- 12 Appendix C GPRS Multi-slot Classes
- 13 Appendix D EDGE Modulation and Coding Schemes
- IC & FCC Requirement
Smart LTE Module Series
SC66 Hardware Design
SC66_Hardware_Design 128 / 139
7.7. Electrostatic Discharge
The module is not protected against electrostatic discharge (ESD) in general. Consequently, it should be
subject to ESD handling precautions that are typically applied to ESD sensitive components. Proper ESD
handling and packaging procedures must be applied throughout the processing, handling and operation
of any application that incorporates the module.
The following table shows the electrostatic discharge characteristics of SC66 module.
Table 61: ESD Characteristics (Temperature: 25°C, Humidity: 45%)
Test Points Contact Discharge Air Discharge Unit
VBAT, GND
+/-5 +/-10
KV
All Antenna Interfaces
+/-5 +/-10
KV
Other Interfaces
+/-0.5 +/-1
KV