Product Info
Table Of Contents
- About the Document
- Contents
- Table Index
- Figure Index
- 1 Introduction
- 2 Product Concept
- 3 Application Interfaces
- 3.1. General Description
- 3.2. Pin Assignment
- 3.3. Pin Description
- 3.4. Operating Modes
- 3.5. Power Saving
- 3.6. Power Supply
- 3.7. Power-on/off Scenarios
- 3.8. Reset the Module
- 3.9. (U)SIM Interfaces
- 3.10. USB Interface
- 3.11. UART Interfaces
- 3.12. PCM and I2C Interfaces
- 3.13. SPI Interface
- 3.14. Network Status Indication
- 3.15. STATUS
- 3.16. ADC Interface
- 3.17. Behaviors of RI
- 3.18. USB_BOOT Interface
- 4 GNSS Receiver
- 5 Antenna Interfaces
- 6 Electrical, Reliability and Radio Characteristics
- 7 Mechanical Dimensions
- 8 Storage, Manufacturing and Packaging
- 9 Appendix A References
- 10 Appendix B GPRS Coding Schemes
- 11 Appendix C GPRS Multi-slot Classes
- 12 Appendix D EDGE Modulation and Coding Schemes
LTE Standard Module Series
EG91 Hardware Design
EG91_Hardware_Design 50 / 93
Table 20: Characteristics of ADC Interface
Parameter Min. Typ. Max. Unit
ADC0 Voltage Range 0.3 VBAT_BB V
ADC Resolution 15 bits
1. It is prohibited to supply any voltage to ADC pins when VBAT is removed.
2. It is recommended to use resistor divider circuit for ADC application.
3.17. Behaviors of RI
AT+QCFG="risignaltype","physical" command can be used to configure RI behavior. The default RI
behaviors can be changed by AT+QCFG="urc/ri/ring" command. Please refer to document [2] for details.
No matter on which port URC is presented, URC will trigger the behavior of RI pin.
URC can be outputted from UART port, USB AT port and USB modem port through configuration via
AT+QURCCFG
command. The default port is USB AT port.
The default behaviors of the RI are shown as below.
Table 21: Default Behaviors of RI
State Response
Idle RI keeps at high level
URC RI outputs 120ms low pulse when a new URC returns
NOTE
NOTES