Product Info
Table Of Contents
- About the Document
- Contents
- Table Index
- Figure Index
- 1 Introduction
- 2 Product Concept
- 3 Application Interfaces
- 3.1. General Description
- 3.2. Pin Assignment
- 3.3. Pin Description
- 3.4. Operating Modes
- 3.5. Power Saving
- 3.6. Power Supply
- 3.7. Power-on/off Scenarios
- 3.8. Reset the Module
- 3.9. (U)SIM Interfaces
- 3.10. USB Interface
- 3.11. UART Interfaces
- 3.12. PCM and I2C Interfaces
- 3.13. SPI Interface
- 3.14. Network Status Indication
- 3.15. STATUS
- 3.16. ADC Interface
- 3.17. Behaviors of RI
- 3.18. USB_BOOT Interface
- 4 GNSS Receiver
- 5 Antenna Interfaces
- 6 Electrical, Reliability and Radio Characteristics
- 7 Mechanical Dimensions
- 8 Storage, Manufacturing and Packaging
- 9 Appendix A References
- 10 Appendix B GPRS Coding Schemes
- 11 Appendix C GPRS Multi-slot Classes
- 12 Appendix D EDGE Modulation and Coding Schemes
LTE Standard Module Series
EG91 Hardware Design
EG91_Hardware_Design 48 / 93
The following tables describe the pin definition and logic level changes of NETLIGHT in different network
status.
Table 16: Pin Definition of Network Status Indicator
Pin Name Pin No. I/O Description Comment
NETLIGHT 21 DO Indicate the module’s network activity status 1.8V power domain
Table 17: Working State of Network Status Indicator
Pin Name Logic Level Changes Network Status
NETLIGHT
Flicker slowly (200ms High/1800ms Low) Network searching
Flicker slowly (1800ms High/200ms Low) Idle
Flicker quickly (125ms High/125ms Low) Data transfer is ongoing
Always High Voice calling
A reference circuit is shown in the following figure.
4
.
7
K
47K
VBAT
2
.
2
K
Module
NETLIGHT
Figure 26: Reference Circuit of Network Status Indicator
3.15. STATUS
The STATUS pin is set as the module’s operation status indicator. It will output high level when the module
is powered on. The following table describes the pin definition of STATUS.