User's Manual

LTE Module Series
BG96-NA Hardware Design
BG96-NA_Hardware_Design Confidential / Released 24 / 64
3.5.1.2. USB Application with USB Remote Wakeup Function
If the host supports USB suspend/resume and remote wakeup functions, the following three preconditions
must be met to let the module enter into sleep mode.
 Execute AT+QSCLK=1 command to enable the sleep mode.
 Ensure the DTR is held in high level or keep it open.
 The host’s USB bus, which is connected with the module’s USB interface, enters into suspended
state.
The following figure shows the connection between the module and the host.
USB_VBUS
USB_DP
USB_DM
AP_READY
VDD
USB_DP
USB_DM
GPIO
Module
Host
GND
GND
Figure 4: Sleep Mode Application with USB Remote Wakeup
 Sending data to BG96-NA through USB will wake up the module.
 When BG96-NA has URC to report, the module will send remote wake-up signals via USB bus so as
to wake up the host.
3.5.1.3. USB Application with USB Suspend/Resume and RI Function
If the host supports USB suspend/resume, but does not support remote wake-up function, the RI signal is
needed to wake up the host. There are three preconditions to let the module enter into the sleep mode.
 Execute AT+QSCLK=1 command to enable sleep mode.
 Ensure the DTR is held in high level or keep it open.
 The host’s USB bus, which is connected with the module’s USB interface, enters into suspended
state.