User's Manual
Table Of Contents
- Contents
- Table Index
- Figure Index
- 0. Revision history
- 1. Introduction
- 2. Product concept
- 3. Application interface
- 3.1. Pin
- 3.2. Operating modes
- 3.3. Power supply
- 3.4. Power on and down scenarios
- 3.5. Power saving
- 3.6. Summary of state transitions
- 3.7. RTC backup
- 3.8. Serial interfaces
- 3.9. Audio interfaces
- 3.10. SIM card interface
- 3.12. Behaviors of the RI
- 3.13. Network status indication
- 3.14. Operating status indication
- 4. Antenna interface
- 5. Electrical, reliability and radio characteristics
- 6. Mechanical dimensions
- 7. Storage and Manufacturing
- Appendix A: GPRS coding schemes
- Appendix B: GPRS multi-slot classes
M95 Hardware Design
M95_HD_V1.0 - 12 -
SM
SIM phonebook
1.3. Directives and standards
The M95 module is designed to comply with the FCC statements. FCC ID is XMR201202M95.
The Host system using M95, should have label indicated FCC ID: XMR201202M95.
1.3.1. FCC Statement
1. This device complies with Part 15 of the FCC rules. Operation is subject to the following
conditions:
a) This device may not cause harmful interference.
b) This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
1.3.2. FCC Radiation exposure statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body as well as kept minimum 20cm from radio antenna depending
on the portable or Mobile status of this module usage.
The manual of the host system, which uses M95, must include RF exposure warning statement to
advice user should keep minimum 20cm from the radio antenna of M95 module depending on
portable or Mobile status.
Note: If a portable device (such as PDA) uses M95 module, the device needs to do permissive
change and SAR testing.
1.3.3. Industry Canada licence
English version
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions:
a) This device may not cause harmful interference.
b) This device must accept any interference, including interference that may cause
undesired operation of the device.