User's Manual
Table Of Contents
- Contents
- Table Index
- Figure Index
- 0. Revision history
- 1. Introduction
- 2. Product concept
- 3. Application interface
- 3.1. Pin
- 3.2. Operating modes
- 3.3. Power supply
- 3.4. Power on and down scenarios
- 3.5. Power saving
- 3.6. Summary of state transitions
- 3.7. RTC backup
- 3.8. Serial interfaces
- 3.9. Audio interfaces
- 3.10. SIM card interface
- 3.12. Behaviors of the RI
- 3.13. Network status indication
- 3.14. Operating status indication
- 4. Antenna interface
- 5. Electrical, reliability and radio characteristics
- 6. Mechanical dimensions
- 7. Storage and Manufacturing
- Appendix A: GPRS coding schemes
- Appendix B: GPRS multi-slot classes
M35 Hardware Design
M35_HD_V1.0 - 12 -
SM
SIM phonebook
1.3. Directives and standards
The M35 module is designed to comply with the FCC statements. FCC ID is XMR201202M35.
The Host system using M35, should have label indicated FCC ID: XMR201202M35.
1.3.1. FCC Statement
1. This device complies with Part 15 of the FCC rules. Operation is subject to the following
conditions:
a) This device may not cause harmful interference.
b) This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
1.3.2. FCC/IC Radiation exposure statement
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body as well as kept minimum 20cm from radio antenna depending
on the portable or Mobile status of this module usage.
The manual of the host system, which uses M35, must include RF exposure warning statement to
advice user should keep minimum 20cm from the radio antenna of M35 module depending on
portable or Mobile status.
1.3.3. Industry Canada licence
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful.
The host system using M35 should have label indicating “transmitter module IC:
10224-201202M35.
This radio transmitter (identify the device by certification number, or module number if Category
II) has been approved by Industry Canada to operate with the antenna type listed below with the
Quectel
Confidential