User's Manual

EVB User Guide
Table 5: Switches and buttons
Part Name I/O Description
S1 POWER I Control power supply from adapter
K1 STANDBY I
The module will enter into standby
mode when pressing this button, and
exit standby mode when releasing
this button.
K2 RESET_N I
Press and release this button. Then
the module will reset.
3.6. Operating Status LEDs
Figure 9: Operating status LEDs
Table 6: Operating status LEDs
Part Name I/O
Description
L1 1PPS O
Flash: fix succes uency is 1Hz sfully, the freq
Extinct: no fix
L2 POWER O
n Bright: Power o
Extinct: Power off
L3 AOK O
na is short-circuit or not
Extinc na operates normally
Bright: Active anten
assembled
t: Active anten
L10_EVB_UGD_V1.00 - 14 -
Quectel