User's Manual

Quectel
3 AT command
（please see the AT command document）
4 FCC Labeling Requirement
Please note：When the M10 is integrated into a final product, the FCC ID label must be visible through
a window on the final device or it must be visible when an access panel，door or cover is easily removed.
If not, a second label must be placed on the outside of the final device that contains the following text：
“Contains FCC ID：XMR-16182009002 ”M10 FCC label is shown as：
5 FCC RF exposure requirements
The maximum measured power output is
30dBm(1900MHz)
33dBm(850MHz),
the maximum antenna gain is
3.0dBi(1900MHz)
0.8dBi(850MHz),
The maximum permissible exposure is defined in 47 CFR 1.1310 with 1 mW/cm
2
.
The transmitter is using indoor antennas that operate at 20 cm or more from nearby persons.
The maximum permitted level is calculated using the general equation:
S = P′/ 4πR
2
GSM850MHz: G=0.8dBi P′= 33dBm+0.8dBi=33.8dBm=2399mW
GSM1900MHz: G=3.0dBi P′= 30dBm+3.0dBi=33.0dBm=1995mw
R = 20 cm
π = 3.1416
Solving for S, the power density at 20 cm is