User guide

Ultrasonic Fuel Sensor User Guide
ACCEUF100UG001 - 17 -
used to fix the detector cable. Please refer to the following figures.
Figure 11. Stainless Steel Hose Clamp
After the detector and the installation surface become dry, put on the disposable plastic mitten and
spread glue in the center of the detector. Don't put too much glue.
As the sand paper may remove paint outside the square frame, protect this exposed area with glue on
the detector (the glue will form a rust-proof film) by moving the detector fast and mildly on the
exposed area. After ensuring that the exposed area is covered with glue and the liquid depth and
signal value are reasonable, press the detector tightly to the location. (Please note that the hold-down
groove on the back of the detector should be parallel with the section of the tank to ensure the
successful installation of the stainless steel hose clamp.)
Wait two minutes for preliminary curing of the glue. During this process, users can also quickly
fine-tune the location based on the reading of the digital tube display (If necessary, an installation
engineer can shake the vehicle by standing on the front of the vehicle.) to ensure the best signal
strength before the glue solidifies.
The glue only needs to cover the area within the red circle as shown in Figure 12.
After the preliminary curing, reinforce the detector with the 304 stainless steel hose clamp and
reinforce the thread with thread sealant, and fix the detector cable with plastic cable ties along the
stainless hose clamp as shown in
Figure 13.
Queclink
Confidential