User manual

ManualsBrandsQueclink ManualsGPSGV320

GV320 User manual

TRACGV3SUM001 - 1 -

GSM/GPRS/GPS Tracker

GV320

User Manual

TRACGV320UM001

Revision: 1.02

http://www.queclink.com

sales@queclink.com

Summary of content (21 pages)

PAGE 1
GV320 User manual GSM/GPRS/GPS Tracker GV320 User Manual TRACGV320UM001 Revision: 1.02 TRACGV3SUM001 -1http://www.queclink.com sales@queclink.
PAGE 2
GV320 User manual Document Title GV320 User Manual Version 1.02 Date 2012-08-14 Status Release Document Control ID TRACGV320UM001 General Notes Queclink offers this information as a service to its customers, to support application and engineering efforts that use the products designed by Queclink. The information provided is based upon requirements specifically provided to Queclink by the customers.
PAGE 3
GV320 User manual Contents 1 Introduction .................................................................................................................................... 7 1.1. Reference ................................................................................................................................... 7 1.2. Terms and Abbreviations ............................................................................................................ 7 2 Product Overview ..........................
PAGE 4
GV320 User manual Table Index TABLE 1. GV320 PROTOCOL REFERENCE ................................................................................ 7 TABLE 2. TERMS AND ABBREVIATIONS .................................................................................. 7 TABLE 3. PART LIST ...................................................................................................................... 9 TABLE 4. DESCRIPTION OF 16 PIN CONNECTIONS .......................................................
PAGE 5
GV320 User manual Figure Index FIGURE 1. APPEARANCE OF GV320 ............................................................................................ 8 FIGURE 2. THE 16 PIN CONNECTOR ON THE GV320.............................................................. 10 FIGURE 3. OPENING THE CASE .................................................................................................. 12 FIGURE 4. CLOSING THE CASE ...................................................................................
PAGE 6
GV320 User manual Revision History Revision Date Author Description of change 1.01 2012-05-07 Owen Feng Initial 1.
PAGE 7
GV320 User manual 1 Introduction The GV320 is a powerful GPS locator designed for vehicle or asset tracking. It has superior receiver sensitivity, fast TTFF (Time to First Fix) and supports Dual-Band GSM frequencies 850/1900, its location can be monitored in real time or be periodically tracked by a backend server or other specified terminals. The GV320 has multiple input/output interfaces that can be used for monitoring or controlling external devices.
PAGE 8
GV320 User manual 2 Product Overview 2.1. Check Part List Before starting, check all the following items have been included with your GV320. If anything is missing, please contact your supplier. k n i l l c a i t e n u Q fide n o C Figure 1.
PAGE 9
GV320 User manual 2.2. Parts List Table 3. Part List Name Picture GV320 Locator 80*49*26 mm User Cable k n i l l c a i t e n u Q fide n o C Extend Cable (Optional) GPS Antenna (Optional) DATA_CABLE_M (Optional) 2.3. Interface Definition The GV320 has a 16 PIN interface connector. It contains the connections for power, I/O, RS232, microphone, speaker, etc.
PAGE 10
GV320 User manual Figure 2. The 16 PIN connector on the GV320 Table 4. Description of 16 PIN Connections Index Description Comment 1 MICP Single end, 2-2.
PAGE 11
GV320 User manual 2.4. GV320 User Cable Colour Table 5.
PAGE 12
GV320 User manual 3 Getting Started 3.1. Opening the Case k n i l l c a i t e n u Q fide n o C Figure 3. Opening the Case Insert the triangular-pry-opener into the gap of the case as shown below, push the opener up until the case unsnapped. 3.2. Closing the Case Figure 4. Closing the Case Place the cover on the bottom in the position as shown in the following figure. Slide the cover against the direction of the arrow until it snapped.
PAGE 13
GV320 User manual 3.3. Installing a SIM Card Open the case and ensure the unit is not powered (unplug the 16Pin cable and switch the internal battery to off position). Slide the holder right to open the SIM card. Insert the SIM card into the holder as shown below with the gold-colored contact area facing down taking care to align the cut mark. Close the SIM card holder. Close the case. k n i l l c a i t e n u Q fide n o C Figure 5. SIM Card Installation 3.4.
PAGE 14
GV320 User manual 3.5. Switch ON the Backup Battery To use the GV320 backup battery, the switch must be at the ON position. Switch on the case and ON/OFF position are shown below. k n i l l c a i t e n u Q fide n o C Figure 7. Switch and ON/OFF position Note: 1-The switch must be on the “OFF” position when shipped on an aircraft. 2-When the switch is on the “OFF” position, the battery cannot be charged or discharged. 3.6.
PAGE 15
GV320 User manual 3.6.1. GPS Antenna Specification Table 6. GPS Antenna Specification GPS antenna: Frequency: 1575.42MHz Bandwidth: >5MHz Beam width: >120 deg Supply voltage: 2.7V-3.3V Polarization: RHCP Gain: Passive: 0dBi min Active: 15dB Impedance: 50Ω VSWR: <2 Noise figure: <3 k n i l l c a i t e n u Q fide n o C 3.7. Power Connection PWR (PIN12) / GND (PIN6) are the power input pins. The input voltage range for this device is from 8V to 32V.
PAGE 16
GV320 User manual Active 5.0V to 32V Inactive 0V to 3V or Open k n i l l c a i t e n u Q fide n o C Figure 10. Typical Ignition Detection IGN (Pin3)is used for ignition detection. It is strongly recommended to connect this pin to ignition key “RUN” position as shown up. An alternative to connecting to the ignition switch is to find a non permanent power source that is only available when the vehicle is running. For example the power source for the FM radio.
PAGE 17
GV320 User manual k n i l l c a i t e n u Q fide n o C Figure 11. Typical Digital Input Connection 3.10. Analog Inputs There are two analog inputs on GV320, the analog input voltage range is from 0 to 16V. The following diagram shows the recommended connection. Figure 12. Typical Analog Input Connection Note: PIN 15 is an multifunction pin: it can be configured as a digital input or an analog input. 3.11.
PAGE 18
GV320 User manual There are three digital outputs on GV320. All are of open drain type and the maximum drain current is 150 mA. Each output has the built-in over current and recovery PTC fuse k n i l l c a i t e n u Q fide n o C Figure 13. Digital Output Internal Drive Circuit Table 9. Electrical Characteristics of Ddigital Outputs Logical State Electrical Characteristics Enable <1.5V @150mA Disable Open drain Figure 14.
PAGE 19
GV320 User manual k n i l l c a i t e n u Q fide n o C Figure 15. Typical Connection with LED Note: 1 - OUT1 will latch the output state during reset. 2- All outputs are internally pulled up to PWR pin by a diode. So no external flyback diode is needed when the output is connected to an inductive load. 3.12. Device Status LED Figure 16. GV320 LED on the Case Table 10.
PAGE 20
GV320 User manual Note: LED Device status LED status GSM (note1) Device is searching GSM network Fast flashing (Note3) Device has registered to GSM network. Slow flashing (Note4) SIM card needs pin code to unlock. ON GPS chip is powered off OFF GPS sends no data or data format error. Slow flashing GPS (note 2) k n i l l c a i t e n u Q fide n o C PWR (note 2) GPS chip is searching GPS info. Fast flashing GPS chip has gotten GPS info.
PAGE 21
GV320 User manual k n i l l c a i t e n u Q fide n o C Figure 17. Typical Connection with RS232 Port 3.13.1 Connect With Garmin GPS Set GV320 can communicate with Garmin GPS Set. The following typical connection is using Queclink AG100 cable. Figure 1. GV320 connection with Garmin GPS set Note: GV320 some version maybe connects with Garmin GPS set by Garmin FMI10/FMI15 cable, please consult with Queclink for detail information.