User's Guide

GPScanID 100 User Operational Manual
Page 7 of 37
Step 2: Charging the Reader
Remove the Data/Charging Cap at the end of the Reader
by turning the cap in an anti-clockwise motion.
Connect and fasten the Data/Charging Cable to the
Data/Charging port on the Reader using a clockwise
motion to secure the cable in place.
Plug the connector on the cable of the Battery Charger
into the socket at the back of the 9 pin serial data
connector on the Data/Charging Cable.
Plug the Battery Charger into mains power and turn the
power on. A red light will indicate the Reader battery is
charging.
The Reader will take about 1 ½ hours to fully charge.