GPS Tracker GB100MG Lite User Manual TRACGB100MGLSUM001 Version:R1.
GB100MG Lite User Manual Document Title GB100MG Lite user manual Version 1.00 Date 2019-12-04 Status Young.Chen Document Control ID TRACGB100MGLSUM001 General Notes Queclink offers this information as a service to its customers, to support application and engineering efforts that use the products designed by Queclink. The information provided is based upon requirements specifically provided to Queclink by the customers.
GB100MG Lite User Manual Contents 0. Revision History ....................................................................................................................... 5 1. Introduction ................................................................................................................................... 6 1.1. Reference............................................................................................................................. 6 2. Product Overview .......................
GB100MG Lite User Manual Table Index TABLE 1. GB100MG LITE PROTOCOL REFERENCE........................................................................ 6 TABLE 2．PART LIST............................................................................................................................ 8 TABLE 3．DESCRIPTION OF 2 PIN POWER CABLE ....................................................................... 8 TABLE 4．DEFINITION OF DEVICE STATUS AND LED ........................................................
GB100MG Lite User Manual Figure Index FIGURE 1. APPEARANCE OF GB100MG LITE .................................................................................. 7 FIGURE 2. GB100MG LITE 2 PIN POWER CABLE ............................................................................ 8 FIGURE 3. OPENING THE CASE ......................................................................................................... 9 FIGURE 4. CLOSING THE CASE......................................................................
GB100MG User Manual 0. Revision History Revision Date Author Description of change 1.00 2019-12-04 Young.
GB100MG User Manual 1. Introduction The GB100MG Lite is a device designed for self-installation by a customer. It simply mounts directly onto the vehicle’s battery with only two wires to attach. This approach allows for either a very low cost installation or for the insurance customer to self-install. Its built-in GNSS receiver has very high sensitivity, a fast time to first fix and supports 10 Hz location sampling during vehicle motion.
GB100MG User Manual 2. Product Overview 2.1. Check Part List Before starting, check all the following items have been included with your GB100MG Lite. If anything is missing, please contact your supplier. Figure 1.
GB100MG User Manual 2.2. Part List Table 2．Part list Name Picture GB100MG Lite Locator 2.3. Interface Definition The GB100MG Lite has a 2 PIN power cable. The pin definition of the 2 pin power cable as below： Figure 2.
GB100MG User Manual 3. Getting Started 3.1. Opening the Case Take out the 6pcs screws from the device and push the opener up until the case unsnapped. 2 3 1 5 Figure 3.
GB100MG User Manual 3.2. Closing the case 1st, make sure the silicon rubber seal ring is in the gap of front case. 2nd, put the power cable wire holder in the rubber groove of rear case. 3rd, place the cover on the bottom in the position as shown in the following figure. Then, press the cover until it snapped (press the LTE antenna side firstly as the arrow shows). 4th, tighten the screws. 2 1 3 4 Figure 4.
GB100MG User Manual 3.3. Installing SIM card open the case and ensure the unit is not powered. and slide the holder left to open the SIM card holder. put the SIM card on the holder as shown below with the gold-colored contact area facing down taking care to align the cut mark. slide the holder right to close the SIM card holder. close the case. SIM Card 5 Figure 5.
GB100MG User Manual 3.4. Power Connection PWR (PIN1) / GND (PIN2) are the power input pins. The input voltage range for this device is from 8V to 32V. The device is designed to be installed in vehicles that operate on 12V/24V vehicle without the need for external transformers. Figure 6. Typical Power Connection Note: 1. Do not connect any external cable on GB100MG Lite device. 2. The GB100MG Lite is simply mounts directly onto the vehicle's battery with only two wires to attach.
GB100MG User Manual 3.5. LED Status Table 4．Definition of Device status and LED LED LED Device status LED status Working Normally Continuous on PDP not activated One flashing: 100ms On, 2s 0f Network not registered or SIM card not inserted Two flashing: 100ms On, 500ms Off, 100ms On, 2s Off... GNSS not fixed k in Three flashing: 100ms On, 500ms off, 100ms On, 500ms Off, 100ms On, 2s off..
GB100MG User Manual 3.6. Motion Sensor Direction GB100MG Lite has an internal 3-axis accelerometer supporting driving behavior monitoring and motion detection. The following shows the direction of the motion sensor. The Z axis faces outwards vertically. Figure 8.
GB100MG User Manual FCC Waring: Any Changes or modifications not expressly approved by the party responsible for compliance could avoid the user’s authority to operate the equipment.open This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
