User's Manual

GB100MG User Manual
TRACGB100MGUM001 - 10 -
3.2. Close the Case
Step_1: Put the motherboard into the front case, and make sure the silicon rubber seal ring is in
the gap of the front case and the power cable wire holder in the rubber groove of the rear case..
Step_2: Insert the battery connector into the socket.
Step_3: Place the cover on the bottom.
Step_4: Press the cover until it snaps into place and tighten the screws.
Figure
3. Close the Case
Qu
e
clin
k
Confi
d
ential