GB100MG User Manual GPS Tracker TRACGB100MGUM001 Version: 1.
GB100MG User Manual Document Title GB100MG User Manual Revision 1.00 Date 2020-03-20 Status Release Document Control ID TRACGB100MGUM001 k n i l l c a i e t u n Q fide n o C General Notes Queclink offers this information as a service to its customers, to support application and engineering efforts that use the products designed by Queclink. The information provided is based upon requirements specifically provided to Queclink by the customers.
GB100MG User Manual Contents Contents ............................................................................................................................................ 2 Table Index ........................................................................................................................................ 3 Figure Index....................................................................................................................................... 4 0. Revision History .........
GB100MG User Manual Table Index Table 1. GB100MG Protocol Reference ............................................................................................. 6 Table 2. Parts List ............................................................................................................................... 8 Table 3. Description of 2-Pin Power Cable ........................................................................................ 8 Table 4. Definition of Device Status and LED....................
GB100MG User Manual Figure Index Figure 1. Appearance of GB100MG ................................................................ ..................................7 Figure 2. Open the Case .................................................................................................................... 9 Figure 3. Close the Case .................................................................................................................. 10 Figure 4. Install a SIM Card...............................
GB100MG User Manual 0. Revision History Version Date Author Description of Change 1.
GB100MG User Manual 1. Introduction The GB100MG is a device designed for self-installation. It simply mounts directly onto the vehicle’s battery with only two wires to attach. This approach allows for either a very low cost installation or for the insurance customer to self-install. It’s built-in GNSS receiver has very high sensitivity, a fast time to first fix and supports 10Hz location sampling during vehicle motion. It’s buit-in Bluetooth can be used for data transmission.
GB100MG User Manual 2. Product Overview 2.1. Check Parts List Before starting, check all the following items have been included with your GB100MG. If anything is missing, please contact your supplier. k n i l l c a i e t u n Q fide n o C Figure 1.
GB100MG User Manual 2.2. Parts List Table 2. Parts List Name Picture GB100MG Locator k n i l l c a i e t u n Q fide n o C 2.3. Interface Definition The GB100MG has a 2-pin power cable. The definition of the 2-pin power cable is shown below. Table 3.
GB100MG User Manual 3. Getting Started 3.1. Open the Case Remove 6pcs screws from the device, insert the triangular-pry-opener into the gap of the case and push the opener up until the case is unsnapped. k n i l l c a i e t u n Q fide n o C Figure 2.
GB100MG User Manual 3.2. Close the Case Step_1: Put the motherboard into the front case, and make sure the silicon rubber seal ring is in the gap of the front case and the power cable wire holder in the rubber groove of the rear case.. Step_2: Insert the battery connector into the socket. Step_3: Place the cover on the bottom. Step_4: Press the cover until it snaps into place and tighten the screws. k n i l l c a i e t u n Q fide n o C Figure 3.
GB100MG User Manual 3.3. Install a SIM Card Step_1: Open the case and pull out the battery connector from the socket to ensure the device is not powered. Step_2: Slide the holder to the left to open the SIM card holder. Step_3: Put the SIM card on the holder with the gold-colour contact area facing down. Take care to align the cut mark. Step_4: Slide the holder to the right to close the SIM card holder. Step_5: Close the case. k n i l l c a i e t u n Q fide n o C Figure 4.
GB100MG User Manual 3.4. Power Connection VIN(PIN1) / GND (PIN2) are the power input pins. The input voltage range for this device is 8V to 32V. The device is designed to be installed in vehicles that operate on 12V/24V vehicle without the need for external transformers. k n i l l c a i e t u n Q fide n o C Figure 5. Typical Power Connection Note: 1. Do not connect any external cable on the GB100MG device. 2. The GB100MG simply mounts directly onto the vehicle’s battery with only two wires to attach.
GB100MG User Manual 3.5. LED Status Table 4.
GB100MG User Manual 3.6. Motion Sensor Direction GB100MG has an internal 3-axis accelerometer supporting driving behaviour monitoring and motion detection. The following shows the directions of the motion sensor. The Z axis faces outwards vertically. k n i l l c a i e t u n Q fide n o C Figure 7. Motion Sensor Direction 4. Bluetooth The device role of Bluetooth could be Master and Slave.
GB100MG User Manual 5. Certification 5.1. FCC Certification The product contains a LTE module FCC ID: XMR201707BG96 FCC Compliance Statement Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules.