Technical data

JSC 36381 MARCH 30, 2000
Baseline
F-3
NOTE
CONTACT SSC OFFICE FOR YOUR NETWORK PARAMETERS
_____ Specify IP address ( Network Neighborhood | properties) for computer
by selecting TCP/IP
_
Proxim RangeLAN2 7400 PC Card Adapter |
properties.
⇒ IP Address: _____________, ⇒ Subnet Mask: _______________
_____ Select OK and reboot.
7. Install RangeLAN2 Site Survey and Configuration tools using the following steps:
_____ Use RangeLAN2,Win95/NT, P/N 9450.0132 Rev. B floppy disk.
_____ Run | a:\setup.exe
_____ Agree to Files to be stored in C:\Program Files\rl2
_____ Reboot when Setup complete.(DO NOT eject RF card)
_____ Launch the RangeLAN2 Site Survey and configuration tool from the start
menu under RangeLAN2 Utilities.
NOTE
CONSULT TABLE 2-4 IN THE OPS LAN ICD TO SET THE CORRECT RF
PARAMETERS (E.G. RF DOMAIN, CHANNEL ETC.)
_____ Click on the configuration button to set correct RF parameters for a
‘Station’ (see table 2-4 in the OPSLAN ICD).
8. Assign IRQ 10 to RangeLAN2 PC card (follow steps below). If necessary, set
remaining IRQs for the PCMCIA devices that will be plugged into your Flight
load (ex. Flash card(s), network card, etc.) If desired, you may reference the IRQ
Plan approved by the S-POCCB, available from the S-POCCB Web page
(http://fltproc.jsc.nasa.gov/s-poccb/Documents/SSC_Pentium.doc).
_____ Insert card in and select My Computer | Device Manager | Network
adapters | Proxim RangeLan2 | Properties | resources tab.
_____ If required, assign IRQ 10 with I/O range 0270-027F, uncheck the use
Automatic settings check box and Select resource type (IR, I/O range) and
click the change settings button.
_____ Specify correct IRQ and correct I/O range.
_____ _No conflicts with other devices and select O.K.
_____ Eject card.
9. In Network Properties, set the Primary Network Logon to ‘Client for MS
Networks’.
_____ Select Network Neighborhood | properties