Technical data

JSC 36381 MARCH 30, 2000

Baseline

F-1

F Checklists

F.1 PAYLOAD CONFIGURATION CHECKLIST FOR OPS

LAN CLIENT

1. Submit an S-POCCB CR to request SSC OPS LAN network resources, such as IP

addresses (http://fltproc.jsc.nasa.gov/s-poccb/Cr-dr/). Contact the S-POCCB

office for CR system access privileges. Reference Chapters 1-4 of this document

for network connectivity rules and guidelines (e.g: network parameters, IRQ’s

Drive mappings etc.).

2. Obtain the following from the SSC Office:

_____ ThinkPad 760XD BIOS floppy disk

_____ AutoLoader floppy disk

_____ RF Networking floppy disk

3. Install the current S-POCCB mandated BIOS v 1.47 (disk version 2.02) on the

ThinkPad 760XD. Execute the following steps to install BIOS:

NOTE

DURING THE EXECUTION OF THE BIOS UPDATE PROGRAM, DO NOT EJECT

FLOPPY DISK, PRESS ANY UNNECESSARY BUTTONS, OR DISCONNECT YOUR

POWER SUPPLY.

_____ Boot laptop from the floppy disk “ ThinkPad 760XGA BIOS Update disk

version 2.02” dated 3/12/98, BIOS ver 1.47.

_____ Select “Update System program”

_____ Follow instructions on screen, at conclusion of update, reboot holding F1

key down.

_____ _BIOS version 1.47 and exit.

_____ Pwr Off ThinkPad and eject floppy disk.

4. Configure the ThinkPad with the S-POCCB mandated CMOS settings using

AutoLoader floppy disk supplied by SSC office. Execute the following steps to

configure CMOS settings:

Appendix