User’s Manual SSCFSSCF-100 & SSCFRSSCFR-100 One Port RS-232 Serial CompactFlash Cards QUATECH, INC. 5675 Hudson Industrial Parkway Hudson, Ohio 44236 TEL: (330) 655-9000 FAX: (330) 655-9010 http://www.quatech.com. CompactFlash Card User’s Manual P/N: 940-0188-110 Version 1.10, 02.05.
Copyright (c) 2003-2004, Quatech, Inc. This manual is copyrighted. All rights are reserved. The information contained in this document cannot be reproduced in any form without the written consent of Quatech, Inc. Likewise, any software programs that might accompany this document can be used only in accordance with any license agreement(s) between the purchaser and Quatech, Inc. Quatech Inc. reserves the right to change this documentation or the product to which it refers at any time and without notice.
Quatech CompactFlash Card User’s Manual SSCF-100 / SSCFR-100 Table of contents 1. Overview............................................................................................................................................. 4 2. About the SSCF-100/SSSCFR-100..................................................................................................... 4 3. Installing the SSCF-100/SSCFR-100 ................................................................................................. 5 3.
Quatech CompactFlash Card User’s Manual SSCF-100 / SSCFR-100 1. Overview The SSCF-100 / SSCFR-100 cards are RS-232 Serial cards with the following features: • • • • • • • • • • • • • • • • • Type I CompactFlash form factor for CF+ equipped PDAs, Handheld, Laptop, & Tablet PCs DOS, Windows 95, 98, 98SE, Me, 2000, XP, CE, & PocketPC compatible using standard drivers Industry standard 16550 register set Transmission rates up to 115.2K Baud as standard. Data rates to 921.6 kbps 3.
Quatech CompactFlash Card User’s Manual SSCF-100 / SSCFR-100 3. Installing the SSCF-100 / SSCFR-100 3.1 Windows CE, PocketPC There is no need to install any software for Windows CE or PocketPC. Simply insert the SSCF100/SSCFR-100 card and it will appear in a list when you set up a “Connection.”For more information about setting up a “Connection” see the manual for your handheld device. 3.
Quatech CompactFlash Card User’s Manual SSCF-100 / SSCFR-100 5. Hardware Specification 5.1 PINOUT The SSCF-100 is supplied with a 300mm long detachable Type45 cable that terminates with a DB9 Male connector with female screw-locks (to match the port at the back of a PC). The pin-out below applies to both the SSCF-100 / SSCFR-100 card and the DB9 male connector on the supplied cable (the cable is pinned one-to-one).
Quatech CompactFlash Card User’s Manual SSCF-100 / SSCFR-100 5.2 ELECTRICAL All figures quoted are typical parameters @ 25°C RS-232 SIGNALS: Typical output level ±5.5V (open circuit voltages) ESD PROTECTION: All RS-232 signal lines on the SSCF-100 / SSCFR-100 card are protected against electrostatic discharge (ESD) • 15kv - human body model • 8kv - IEC1000-4-2, contact discharge • 15kv - IEC1000-4-2, air-gap discharge UART CLOCK SPEED: x1: UART CLOCK is 1.8432MHz ->115.
Quatech CompactFlash Card User’s Manual SSCF-100 / SSCFR-100 5.6 NOTES ON SERIAL DATA THROUGHPUT The maximum serial baud rate of 921KBits/sec does not imply that the maximum sustained throughput rate of the serial port will be as high.
Quatech CompactFlash Card User’s Manual SSCF-100 / SSCFR-100 6. Warranty information Quatech, Inc. warrants the SSCF-100 / SSCFR-100 to be free of defects for five (5) years from the date of purchase. Quatech, Inc. will repair or replace any board that fails to perform under normal operating conditions and in accordance with the procedures outlined in this document during the warranty period. Any damage that results from improper installation, operation, or general misuse voids all warranty rights.
