User`s manual

2-11
SSP-100 (Rev. G and later) User's Manual
2.2.1.5 Example 5
SSP130EN.EXE (o1,i5,b340,s1)
In example 2, the Enabler will configure the SSP-100 in socket 1 with a base address of
340H and IRQ 5 using a configuration memory window at segment D000.
2.2.1.6 Example 6
SSP130EN.EXE (s0,b300,i5,r)
In example 6, the Enabler will release the configuration used by the SSP-100 in socket 0
using a configuration memory window at segment D000. The base address and IRQ
parameters are ignored and may be omitted.
2.2.1.7 Example 7
SSP130EN.EXE (s1,r,wcc)
In example 7, the Enabler will release the configuration used by the SSP-100 in socket 1
using a configuration memory window at segment CC00.
2.2.2 Common Problems
Memory Range Exclusion:
The Enabler requires a region of high DOS memory when configuring a SSP-100. This
region is 1000H bytes (4KB) long and by default begins at address D0000H (the default
address may be changed using the "W" option). If a memory manager such as
EMM386, QEMM, or 386Max is installed on the system, this region of DOS memory
must be excluded from the memory manager's control. Consult the documentation
provided with the memory manager software for instructions on how to exclude this
memory region.
Furthermore, some systems use the high memory area for BIOS shadowing to improve
overall system performance. In order for the Enabler to operate, any BIOS shadowing
must be disabled in the address range specified for the configuration window. BIOS
shadowing can usually be disabled through the system's CMOS setup utility.
Socket Numbers:
The Enabler requires the SSP-100's socket number to be specified on the command line
and the SSP-100 must be inserted into the socket before the Enabler is invoked. Some
vendors number their sockets from 1 to N while other vendors number their sockets
from 0 to N-1. For theSSP-100 Enabler, the lowest socket number in the system is
designated socket 0.