Specifications

3.9.18 Show
The show command lets you examine the machine state. Table 3–15 describes
the available machine states that you can examine.
Format: SHOW [machine_state]
Table 3–15 Show Command Machine States
Machine State Description
Breakpoints Active breakpoints
GDT Global descriptor table entries
IDT Interrupt descriptor table entries
Physical Physical address of specified logical address
Task Task state segments for each task
TSS Individual task state segment
3.9.19 Status
The status command (or
Ctrl/T
) lets you display the test statistics for all tests.
The command also lets you display the status of all devices that are under test.
Format: STATUS [option]
The test statistics that you can display are:
• Test number and description
• The letter B to the left of the test name, if a test is blocked
• Test module revision level
• Total number of test passes made
• Total number of errors detected in each test
• Total number of page faults encountered in each test
For example, to obtain the status of all SYSEX tests, enter status or st at the
prompt:
RUN> status
Enter
3–24 System Exerciser