Specifications

3.9.15 Quit
You can use the quit command to end a test run and reboot the system.
Format: QUIT
You can also use the key sequence
Ctrl/Alt/Delete
to duplicate the quit command.
3.9.16 Run
The run command lets you run SYSEX tests continuously.
Format: RUN [test_time_in_minutes]
To start or resume testing, enter run or r at the HLT> prompt as follows:
HLT> run
Enter
RUN>
All unblocked tests begin executing immediately. Devices are tested
concurrently. Testing continues until you press
Ctrl/C
or until an error is
encountered while the halt flag is on. Section 3.8 provides information on how
to use SYSEX flags.
While the tests run, you can execute the status command at the RUN> prompt
to obtain information about SYSEX tests.
3.9.17 Set
The set command lets you set or display state variables.
Format: SET [variable [value]]
Table 3–14 describes the available state variables that you can set or display.
3–22 System Exerciser