Specifications

To review an error report from the log, use the log play command and specify
the entry number of the error. For example, to review entry 0 from the sample
report in Table 3–13:
RUN> log play 0
Enter
You can specify one entry number to review a single error report or a range of
entry numbers to review several error reports. However, you cannot enter both
single numbers and a range of numbers on the same command line.
Memory space for error reports is limited, but there should be space available
for at least 50 error reports.
Note
When the error log is full, new error reports are not included in the
error log. Errors must be cleared before new error reports can be
included.
To remove an error report from the log, use the log clear command and specify
an entry number obtained from the error summary report. For example, to
remove entry 0 from the sample report in Table 3–13:
RUN> log clear 0
Enter
Note
Error reports that have been removed from the error log are
permanently deleted; they cannot be restored.
You can specify one entry number to remove a single error report or a range
of entry numbers to remove several error reports. However, you cannot enter
both single numbers and a range of numbers on the same command line.
System Exerciser 3–21