Specifications

You can use the following functions with the calculate command:
• Add (+)
• Subtract (-)
• Multiply (*)
• Divide (/)
• Exponentiation (^)
The order of precedence is:
• Exponentiation (highest precedence)
• Multiply or divide
• Add or subtract (lowest precedence)
Use parentheses to change the order.
3.9.4 Configuration
The configuration command lets you display the same system and EISA bus
configuration information that was displayed during initial SYSEX startup.
Format: CONFIGURATION
RUN> configuration
Enter
3.9.5 Ctrl/C
Press
Ctrl/C
at any time to suspend testing and enter halt mode.
Note that although testing is stopped when suspended, the clock that measures
elapsed test time continues to operate. The clock will always reflect the elapsed
time since you started testing. If you suspend testing, the clock does not reflect
the actual test time.
3.9.6 Devices
The devices command lets you display or modify the flag state of devices
under test.
Format: DEVICES [device[/n] [flag_list]
The devices command is extremely useful for changing the test state of
devices that were set up incorrectly at the start. Without this command, you
would have to reboot SYSEX to set up the device tests differently.
3–14 System Exerciser