Specifications

Scheduled tests:
Test Name Rev
==== ==== ===
1. Memory 1
2. Memory Retention 1
3. Numeric 0
4. Serial Line (COM1) 2
5. Serial Line (COM2) 2
6. Motherboard [Slot 0] 2
7. Parallel Port (LPT1) 1
8. Console 1
9. SCSI Disk 3:0:0 1
10. SCSI Disk 3:1:0 1
11. Floppy Disk 0:0 1
12. Floppy Disk 0:1 1
13. 8x4 Mux [Slot 11] 2
14. Ethernet/2 (DE200) 0
Type "HELP" for information, "RUN" or "IVP" to begin testing
HLT>
When the HLT> prompt is displayed, you can run the 15-minute installation
verification procedure (IVP). Type the ivp command and press
Enter
:
HLT> ivp
Enter
You can run the IVP for less than the full 15 minutes by specifying a number
of minutes in the ivp command. The following command specifies 5 minutes:
HLT> ivp 5
Enter
When the IVP is running, the following message is displayed:
Installation Verification Procedure Running
Also, the HLT> prompt will change to RUN>.
After 15 minutes (default time), a success message is displayed, indicating that
the system is functional. Then the HLT> prompt is reissued:
Installation Verification Procedure Complete: No Errors Detected
HLT>
If an error is detected, an error report is displayed immediately and the IVP is
aborted. See Section 3.5 for details on how to interpret the error report.
If you wish to rerun the IVP, you must reboot the system exerciser. You cannot
rerun the IVP by typing ivp again. By typing the run command, you can run
the same tests without rebooting the system, but the tests run continuously
(without the 15-minute timeout).
Type status to see error summaries. Press
Ctrl/C
to stop the tests. Type quit
to reboot.
System Exerciser 3–5