Specifications

3.3 Running the System Exerciser

Note

Before you run SYSEX, verify the system conﬁguration with the system

conﬁguration utility (SCU). For information on conﬁguring the system

with the SCU, refer to Chapter 5.

When the system exerciser has been booted, system conﬁguration information

is displayed on the screen:

03/12/92 15:00:08 applicationDEC System Exerciser Rev 4.0 400xP 0000:00:00

applicationDEC System Exerciser Rev 4.0 03/01/92

applicationDEC 400xP

Unpublished-rights reserved under the copyright laws of the United States.

Verifying program loaded correctly

System Configuration:

Slot Type

==== ====

0 33MHz Viceroy Motherboard

0 0 KB Secondary Cache

0 16MB Memory

EISA slot configuration:

Slot IRQ Ports Type

==== === ===== ====

0 6 3F0-3F7 Floppy controller

0 7 378-37B Parallel port, LPT1

0 4 3F8-3FF Serial port, COM1

0 3 2F8-2FF Serial port, COM2

0 Video Adapter (80x25 color)

1 10 D0000 8x4 Mux

3 11 330-332 Adaptec 1540B, firmware rev = 05

2 5 300-30C DE200 Ethernet, Node addr = 08-00-2B-27-73-31

Load scratch media into all drives to be tested in write-read mode

Hit any key to continue

After you load the drives to be tested, press

Enter

. The following message is

displayed.

Is a printer connected to COM1 (Y/N)?

Enter your response by pressing

. The following message is displayed:

Sizing devices (please wait - up to 5 min.) ...

System Exerciser 3–3