Specifications

Table 2–7 Disk Drive Troubleshooting
Problem Possible Cause Action
IDE/SCSI hard
disk drive cannot
read or write
information
Incorrect jumper
settings
Refer to the supplied kit installation
instructions.
Loose or incorrectly
installed cables
Make sure all cables are correctly
installed.
IDE/SCSI hard
disk drive is not
properly formatted
or partitioned
Format and partition as required using
the supplied operating system.
IDE drive type
incorrect
Run the SCU to identify the correct
drive type.
System not configured
for SCSI hard disk
operation
Run the SCU to configure the system
for SCSI operation.
Target diskette
drive cannot
read or write
information
Diskette is not
formatted
Format the diskette.
Diskette is worn or
damaged
Try another diskette.
Diskette is write-
protected
Slide the write-protect switch so the
hole is not visible (3.5-inch diskette)
or uncover the write-protect notch
(5.25-inch diskette).
Diskette drive is empty Insert a diskette.
System Troubleshooting 2–23