Specifications

Table 2–6 (Cont.) System Troubleshooting
Problem Possible Cause Action
IDE hard disk drive is
not properly formatted
or the requested
partition does not
exist
Format the IDE hard disk drive or
correctly partition the IDE hard disk
drive using the supplied operating
system software.
There is no software
on the requested
partition
Install software on the requested
partition.
IDE hard disk drive
jumpers incorrectly set
Refer to the supplied IDE hard disk
drive kit installation instructions.
IDE drive type
incorrect
Run the SCU to identify the correct
drive type.
Loose cables Check all cable connections.
System does not
boot from a SCSI
hard disk drive
Operating system
software is not
installed on the SCSI
hard disk drive
Install the operating system.
Requested partition
does not exist
Partition the SCSI hard disk drive and
then reload the operating system.
SCSI hard disk drive
jumpers incorrect
Refer to the supplied SCSI hard disk
drive kit installation instructions.
SCSI ID conflicts Refer to the supplied SCSI hard disk
drive kit installation instructions on
setting SCSI IDs.
Terminating resistors
not removed from the
SCSI hard disk drive
Remove terminating resistors. Refer
to the supplied kit installation
instructions.
System not configured
for SCSI hard disk
operation
Run the SCU to configure the system
for SCSI operation.
IDE drive is configured
in the system
Remove the IDE drive or install the
boot software on the IDE drive.
(continued on next page)
System Troubleshooting 2–21