Specifications

If POST does not detect any configuration errors, the system beeps once and
displays a message similar to the following:
PhoenixBIOS (TM) E486 Version x.xx.xx.xxx
Copyright (c) 1985-1991 Phoenix Technologies Ltd.
All Rights Reserved
...
640K Base Memory
03072K Extended
000
To continue press:.................................SPACEBAR
To configure system press:...............................F1
Note
After the above message appears, you have approximately 10 seconds
to press the appropriate function key to display the initial setup screen.
If you do not press the appropriate function key within the specified
time, and if POST failed to detect any configuration errors, the system
will continue with the boot sequence.
If configuration errors are found, the system beeps more than once and displays
a message similar to the following:
PhoenixBIOS (TM) E486 Version x.xx.xx.xxx
Copyright (c) 1985-1991 Phoenix Technologies Ltd.
All Rights Reserved
...
640K Base Memory
03072K Extended
150: Invalid configuration information
To continue press:......................................Esc
To configure system press:...............................F1
It is normal for the above message to appear the first time you start the
system. Run the system configuration utility (SCU) to create a valid system
configuration. If any other error messages appear on the screen, refer to
Section 2.3.4 for decriptions and solutions.
2–4 System Troubleshooting