Specifications

B
System Board Jumpers
B.1 Introduction
Jumper pins allow you to set specific system parameters. They are set by
changing the pin location of jumper blocks. A jumper block is a small plastic-
encased conductor (shorting plug) that slips over the pins. To change a jumper
setting, remove the jumper from its current location with your fingers. Position
the jumper over the two pins designated for the desired setting. Press the
jumper evenly onto the pins. Be careful not to bend the pins.
B.2 Jumper Settings
Figure B–1 shows the location of the system board jumpers. Table B–1 lists
the system board jumpers and factory default settings.
System Board Jumpers B–1