Specifications

Table 4–28 Key for Figure 4–26
Key Description
A Front panel
B Speaker wires
C Push-on ground terminal
D System board connector
4.17 Replacing a Fan
The following steps describe the removal procedure for a fan. Refer to
Figure 4–27 during the procedure.
1. Remove the top cover and left side panel using the procedure in Section 4.5.
2. Loosen the four captive screws that secure the fan to the chassis.
3. Unplug the fan power connector located along the left side of the chassis.
4. Pull the fan out of the front of the chassis.
Reverse the above procedure to install the replacement fan.
FRU Removal and Replacement 4–53