Specifications

Table 4–27 Key for Figure 4–25
Key Description
A Speaker
B Speaker connector tab (1 of 2)
C Retaining spring
4.16 Replacing the Front Panel Wire Assembly
The following steps describe the removal procedure for the front panel wire
assembly. Refer to Figure 4–26 and Table 4–28 during the procedure.
1. Shut down the system and unplug the power cord (Section 4.4).
2. Remove the top cover, side panels, card cage cover, and upper front bezel
using the procedure in Section 4.5.
3. Remove the CPU module using the procedure in Section 4.6.
4. Remove the memory module retaining bar, and the memory module (if one
is present), using the procedure in Section 4.9.
5. Remove the screw that secures the front panel to the RX23 drive adapter
plate. Save this screw.
6. Disconnect the two speaker wire push-on terminals (white and black wires)
from the speaker connector tabs (see Figure 4–25).
7. Disconnect the push-on ground terminal (black wire) from the chassis
ground connector tab.
8. Disconnect the system board connector (see Figure 4–11 and Table 4–13).
9. Pull the wire assembly and system board connector up through the chassis
opening into the upper storage bay area.
10. Pull the wire assembly and system board connector through the opening in
the RX23 drive adapter plate.
Reverse the above procedure to install the replacement front panel wire
assembly.
FRU Removal and Replacement 4–51