Specifications

Table 4–26 Key for Figure 4–24
Key Description
A Power connector
B Grounding jumper
C Density jumper
D Data connector
4.15 Replacing the Speaker
The following steps describe the removal procedure for the speaker. Refer to
Figure 4–25 and Table 4–27 during the procedure.
1. Remove the top cover and side panel using the procedure in Section 4.5.
2. Disconnect the two speaker wire push-on terminals (white and black wires)
from the speaker connector tabs. The speaker wires are part of the front
panel wire assembly.
3. Press the right side of the speaker retaining spring down, out, and up.
4. Lift the speaker up and out of the chassis.
Reverse the above procedure to install the replacement speaker.
FRU Removal and Replacement 4–49