Specifications

Table 4–23 Key for Figure 4–21
Jumper
Operating
Position Description
0, 1, 2 — SCSI ID jumpers. ID 3 shown.
A None FLT_SINK signal (lower pin [7]) — for connection to a
remote fault LED cable.
B Out BSY_SINK signal (lower pin [9]) — for connection to a
remote busy LED cable. Do not install jumper.
C Out
5.0 V (lower pin [11]) — power connection for remote
LEDs. Do not install jumper.
D In Spin-up on power when installed. Spin-up on START
INIT command when removed.
E Out ACOK signal (lower pin [15]). Do not install jumper.
F Out Reserved. Do not install jumper.
G Out SPNDL_SYNC_REF signal (lower pin [19]). For
manufacturing use. Do not install jumper.
FRU Removal and Replacement 4–43