Specifications

Table 4–15 Key for Figure 4–13
Key Description
A RX23 drive
B Adapter plate
C Mounting bracket
4.14 Replacing an Option Drive
The following steps describe the removal procedure for the disk and tape drive
options installed in the front and rear bays of the system cabinet. Refer to
Figure 4–14 and Table 4–16 during the procedure.
1. Remove the top cover, side panels, and upper bezel using the procedure in
Section 4.5.
2. Disconnect the power and data cables from the rear of the drive.
3. Loosen the two captive screws that secure the drive mounting bracket.
4. Slide the mounting bracket out of the chassis.
5. Remove the drive mounting screws and lift the drive off the mounting
bracket. Save these screws.
6. Remove the replacement drive from its protective package.
7. Ensure that the jumpers on the replacement drive match the positions
of the jumpers on the failed drive. Refer to Section 4.14.1, Option Drive
Installation Data.
Reverse the above procedure to install the replacement drive.
FRU Removal and Replacement 4–31