Specifications

8. Use a flat-blade screwdriver to lift the chip from its socket.
9. Dispose of the chip as follows:
a. Clip all exposed chip leads. Do not short any leads together.
b. Wrap the chip in insulating tape to prevent accidental shorting.
c. Pack the chip so it cannot be crushed.
d. Place the chip into an appropriate trash receptacle.
10. Carefully remove the replacement real-time clock chip from its antistatic
package. Do not touch its pins.
11. Position the chip over the socket on the system board so that pin 1 (marked
with a dot) is aligned with the pin 1 mark on the system board.
12. Align the pins of the chip with the socket.
13. Gently insert the chip, being careful not to bend the pins.
14. Install the CPU module and the memory module (if one was present).
15. Replace the card cage cover, side panel, and top cover.
16. Boot the system and run the SCU following the procedure given in
Chapter 5.
FRU Removal and Replacement 4–27