User`s manual

6, 7The 4th PCMCIA Card Drive
4, 5The 3rd PCMCIA Card Drive
2, 3The 2nd PCMCIA Card Drive
0, 1
(Default)
The 1st PCMCIA Card Drive
Socket NO.JP2 & JP1PCMCIA Card Drive
.
These setting allow more than one PCD2-F to be installed in the computer at the same time
without conflict. Use the table above to set the jumpers accordingly. Note, the jumper
configuration is factory set at 2-3 on both JP3 and JP4.
The jumpers do not need to be changed if only one PCD2-F is used.
2.2.2 Instructions for Installation
1. Turn off the PC and all peripherals.
2. Remove the cover.
3. Attach the ribbon cable to the drive unit. The ribbon is keyed, therefore, there is only
one possible way to insert the plugs into the sockets.
4. Install the PCD2-F into an unused 3.5" drive bay using the four mounting screws. The
optional PCD2 adapter will be required installation in a 5.25" drive bay. Follow the
instructions on the drive bay adapter for installation in the 5.25" drive bay.
5. Attach the ribbon cable to the drive unit’s ISA bus interface card. Again, the ribbon
cable is keyed for proper insertion.
6. Find an empty ISA/AT (16-bit) bus slot for the card and remove the empty card socket
plate from the PC and retain the fastening screw.
7. Insert the card into the empty slot, being careful to line up the tabs with the sockets.
8. Fasten the card in place with the screw from step seven (7).
The hardware installation is now complete.
PCD2-F User’s Manual 4