User`s manual

7.0 TROUBLESHOOTING
The following are common problems that can occur while installing and using the
PCD2-F.
1. During the installation of the Cardsoft drivers, the screen in Figure 3 appears.
a. The Host Interface Adapter may not be installed correctly or has never been
installed.
b. The jumper setting may not be set to the default location.The default value (I/O
address 03E0-03E1) is being used by another device within the PC. When using a
value other than the default the screen as shown in figure 3 will appear. Select
"Intel 82365SL Socket Service" and continue with the installation.
c. The PCD2-F may be defective.
Intel 82365SL Socket Service
Databook Socket Service
Cirrus Socket Service
VLSI Socket Service
Intel 82365LP Socket Service
IBM720 Socket Service
Not Installed Socket Service
Figure 3
2. During the system booting the following message appears:
*** Installation Failed: Intel 82365SL PCMCIA Adapter not found.
a. A hardware or software conflict may exist between the PCMCIA controller and
some other device or program in the system.
b. The PCD2-F may be defective.
3. The PC already contains a version of card and socket services. If the version of card
and socket services is dated 1993 and before, the PCD2-F and any Quatech PCMCIA
card may not function. Install the new version of card and socket services after
removing the old version of the software.
4. During the installation of the Cardsoft Utility, the PC freezes operation while loading
the drivers to the hard drive.
a. Not enough memory has been allocated. The Cardsoft utility needs a minimum of
1K of memory to load the drivers. Consult the PC manual for information on how
to free memory.
5. There is an address conflict between the PCD2-F and an existing device in the PC.
a. The PCD2-F can only use the address range of 03E0 - 03E7.
PCD2-F User’s Manual 18