User`s manual

3. Find the line that contains "flash" or some variation of it in the driver name (such as

ms-flash.sys) and remove the text "REM-by PC Card (PCMCIA) Wizard-" from the

beginning of that line. This line must be after the lines added in step 2.

4. Save the changes made to the CONFIG.SYS, and then re-start the system.

4.3.3 Using Flash Cards Under OS/2 Warp

Before using flash cards in the OS/2 Warp environment, the user must have the OS/2 Warp Flash

File System installed. If "Flash Cards" was selected when Card and Socket Services was

installed, the system should be ready for flash card use. If the Flash File System was not

installed, then it must be added using "Selective Install". Simply follow this procedure to install

the OS/2 Warp Flash File System :

1. Double click on the "OS/2 System" icon.

2. Double click on the "System Setup" icon.

3. Users of OS/2 Warp version 4.00 must double click on the "Install/Remove" icon,

then double click on "Selective Install". Users of OS/2 Warp version 3.0 and before

can just double click the "Selective Install" icon.

4. Select the icon labeled "PCMCIA Support". Click on the box labeled "Flash Cards",

then click "OK".

5. When prompted for the OS/2 Installation CD or diskettes, insert the CD or diskette

into the drive, be certain the correct path is selected, and press <ENTER>.

6. A shutdown and re-start of OS/2 Warp will be necessary before beginning use of the

Flash File System.

Once the Flash File System is installed and loaded, the user may begin using flash cards. For

information on how to format or use the flash cards with the OS/2 Warp utilities, consult the

OS/2 on-line help.

4.4 USING LAN CARDS

4.4.1 Using Lan Cards under DOS and Windows 3.1x

Insert the LAN card into the PCD2-F. Hearing two beeps indicates the LAN card has

been correctly configured. Go into the Cardsoft directory and type " CARDINFO /V, then press

<Enter>. A listing similar to the one below will appear.

Slot 0:

[Card Information]

Card Type= " Ethernet"

Manufacturer=<Vendor Name>

PCD2-F User’s Manual 13