User`s manual

To install support for SRAM cards under a Windows 95 environment, simply follow these
instructions:
1. Double Click on the PC Card (PCMCIA) Wizard, When prompted to restart the
computer after finishing the PC Card Wizard, select "NO".
2. Use a text editor to edit the CONFIG.SYS file, and add the following lines in order to
the end of the CONFIG.SYS file:
device=c:\windows\system\csmapper.sys
device=c:\windows\system\carddrv.exe /slot=n
(where n = the number of sockets installed within the system.) It is also important to
be certain that these files are located in the Windows/System folder.
3. Save the changes to the CONFIG.SYS file, then re-start the computer.
4.3 USING FLASH CARDS
4.3.1 Using Flash Cards in DOS and Windows 3.1x
To use flash cards, an optional Flash File System II is required. Refer to the section
"Before Using PC Cards" to be sure the proper drivers are loaded into the CONFIG.SYS file.
Before using a Flash Card, the card must be formatted. To format Flash Cards, type "cd
Cardsoft" from the DOS prompt and press<Enter>. It is required to execute the MEMCARD
utility from Cardsoft. When MEMCARD is executed, a menu with various options will appear.
To format, erase the card’s contents first. When this is completed, select " Format a New
Partition." This process will take several minutes. Once the format is completed, the Flash Card
is ready for use. The Flash Card can be used in a manner similar to that of a floppy disk, i.e..,
files and information can be stored there.Using
4.3.2 Flash Cards Within Windows 95
Windows 95 Card and Socket Services does not have a Flash File System installed automatically.
The user must install the Flash File System manually.
To install the Microsoft Flash File System, simply follow these instructions:
1. Start the PC Card (PCMCIA) Wizard by inserting the card. When prompted to restart
the system, select "NO".
2. Use a text editor to edit the CONFIG.SYS file. Insert the following lines in this order
just before the line that contains the "flash" in the driver name:
device=c:\windows\system\csmapper.sys
device=c:\windows\system\carddrv.exe /slot=n (Where n = the number of PC Card
sockets installed on the system). Also, it is very important to be certain these files are
in the Windows\System folder.
PCD2-F User’s Manual 12