User`s manual

To install "ATA Support" simply follow these instructions :
1. Double click on the "OS/2 System" icon.
2. Double click on the "System Setup" icon.
3. User’s of OS/2 Warp before version 4.00 must double click on the "Selective Install"
icon. User’s of OS/2 Warp version 4.00 must double click on the "Install/Remove "
folder to find "Selective Install". Once the "Selective Install" folder appears, double
click on the icon.
4. Select the "PCMCIA Support" icon.
5. Click on the box labeled "ATA Support".
6. Select "OK". OS/2 will prompt the user for the OS/2 Installation CD or diskettes.
Insert the CD or installation diskettes into the drive. Be certain that the path
displayed on the screen is the correct path.
7. The OS/2 Warp CONFIG.SYS file will be updated to include ATA card support.
8. A shutdown of OS/2 Warp will be required before ATA cards can be used under the
OS/2 Warp environment.
9. Once a shutdown and re-start of OS/2 Warp has been completed, ATA cards may
then be used within the OS/2 Warp environment.
4.2 USING SRAM CARDS
4.2.1 Using SRAM Cards Under DOS and Windows 3.1x
Insert the card(s) into the PCD2-F. Drive letter(s) will be reserved for the card(s). Find out
which drive letter(s) have been assigned by going into the Cardsoft directory and type
"MTDDRV /V" and pressing <Enter>. The following or a message similar to the
following will be displayed.
Drive D is partition number 00 for slot 00
Drive E is partition number 11 for slot 01
In the above example, drive letter D is assigned to slot 0, and drive letter E is assigned to
slot 1. All standard DOS commands, including FORMAT, will work with the SRAM
cards.
4.2.2 Using SRAM Cards Within a Windows 95 Environment
PCD2-F User’s Manual 11