User`s manual

II. INSTALLATION
If the default address and interrupt settings are sufficient, the
QS/ES-100M can be quickly installed and put to use. The factory defaults
are listed in Figure 1.
PORT ADDRESS IRQ
Serial 1 300 hex 3
Serial 2 308 hex 3
Serial 3 310 hex 3
Serial 4 318 hex 3
Serial 5 (ES only) 320 hex 3
Serial 6 (ES only) 328 hex 3
Serial 7 (ES only) 330 hex 3
Serial 8 (ES only) 338 hex 3
Figure 1 --- Default address and IRQ settings for QS/ES-100M
The outputs of the QS/ES-100M are provided with RJ-11
connectors. See section V of this manual for connector details.
1. If the default settings are correct, skip to step 2, otherwise refer to
sections III and IV of this document for detailed information on
how to set the address and IRQ level.
2. Turn off the power of the computer system in which the
QS/ES-100M is to be installed.
3. Remove the system cover according to the instructions provided by
the computer manufacturer.
4. Install the QS/ES-100M in any vacant expansion slot. The board
should be secured by installing the Option Retaining Bracket (ORB)
screw.
5. Replace the system cover according to the instructions provided by
the computer manufacturer.
6. Attach and secure the cable connectors to the desired equipment.
2
Quatech QS-100M/ES-100M User's Manual